OFF ON BASS +3dB TREBLE +3dB VOLUME / INPUT Dongguan Platinum Audio Systems Co., LTD No. 2 East Industry Road, Songshan Lake National High-tech Industrial Development Zone, Dongguan 523808 China www.airpulseaudio.
Important safety instruction Important safety instruction Please read the following contents carefully before turning on your equipment; and follow the instructions below. Keep this information around for future reference. 1. Please read the instructions carefully. Keep it in safe place for future reference 2. Heed all warnings. 3. Follow all instructions. 4. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 5.
Important safety instruction Catalog FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Speaker illustration Box contents Speaker OFF Remote control OFF R ON BASS +3dB TREBLE +3dB L VOLUME / INPUT ON BASS +3dB TREBLE +3dB VOLUME / INPUT RCA audio cable 3.
Installing battery in remote control Remote control illustration ① Infrared emission window ② Standby button Standby/power on Open Close Playback selection buttons ③ Previous/ next track ④ Play/pause Previous/next track in Bluetooth input Play/pause in Bluetooth input 1.Insert a coin into the slot and rotate counter-clockwise to open the battery compartment. 2.Install the new battery, close battery compartment and rotate the cover clockwise to close the compartment.
Preparations Playback instruction Connect to playback devices Connect to power source * Connect the power cable included to power input port on the rear panel, and then insert power plug into the mains socket on the ground or on the wall. * Refer to the "Power switch" on page 6 to turn on/off the speaker, and press the " " button on the remote control to switch to Standby/Power on state. 1.
Playback instruction Specifications/statement Playing 1.For line in input, please ensure the orange light is lit; if not, please press the "VOLUME/INPUT" dial to select line in input, then press the playing button on your device to play music, and adjust volume to a desired level with the "VOLUME/INPUT" dial. 2.For Bluetooth input, please ensure the blue light is lit and the speaker and Bluetooth device are paired (if not, please follow the pairing method mentioned above to complete pairing.
Troubleshooting No sound •Check if the speaker is powered on. •Try to turn up the volume using either the master volume control or remote control. •Ensure the audio cables are firmly connected and the input is set correctly on the speaker. •Check if there is a signal output from the audio source. Cannot connect via Bluetooth •Make sure the speaker is switched to Bluetooth input, in other audio input mode Bluetooth can not be paired or connected.
