User Manual

R
L
R
L
Connect to playback devices
Connect to power source
Speaker placement
109
AIRPULSE P100X
Bluetooth
Preparaons
Playback instrucon
CD player/music player
/audio decoder, etc.
PC or Mac
CD player
RCA audio cable
2. Bluetooth input: Please switch to Bluetooth input mode, and set your Bluetooth
device to search for and connect to "AIRPULSE P100X".
* Connect the power cable included to power input port on the rear panel, and then
insert power plug into the mains socket on the ground or on the wall.
* Refer to the "Power switch" on page 6 to turn on/off the speaker, and press the
" " buon on the remote control to switch to Standby/Power on state.
(Note: Turning off the power switch will only turn the amplifier off, and power source
is sll available. To thoroughly turn the speaker off, please unplug the power cable
from the mains socket.)
* Place the speaker on a solid, leveled and steady surface.
* The speaker with compact and delicate look can be easily carried around. It can
also be placed on desktop, in bedroom, in living room, or at any other indoor
corners. Make your room full of vitality.
1. Line In input: Insert the RCA audio cable included into the "LINE IN" port on the
speaker; then connect the RCA audio cable to your playback device.
Note:
* Pin code for connecon is "0000" if needed.
* For inial pairing, the blue light will flash, and will be steady lit aer pairing is successful. If
the blue light flashes in a breathing paern, it means the pairing failed, please pair again.
Operaons may be different among different devices, please refer to the operaonal
instrucons aached with the devices.
* Effecve Bluetooth connecon distance is within 10 meters.
* The Bluetooth of P100X can only be searched and connected in Bluetooth input. The exisng
Bluetooth connecon will be disconnected once the speaker is switched to line in input.
When switched to Bluetooth input, the speaker will try to connect to the Bluetooth device
connected last me.
* To disconnect Bluetooth, press and hold the " " buon on the remote control for over 2
seconds, or press and hold the "VOLUME/INPUT" dial on the front panel of the speaker.
* To enjoy all Bluetooth funcons please ensure your audio device has A2DP(Advanced Audio
Distribuon Profile) and AVRCP(Audio Video Remote Control Profile) profiles.
* When connected to this product, Bluetooth connecvity and funcons may be different
among different Bluetooth devices, depending on soware sengs of Bluetooth devices.