User`s guide

Installation
2-4
Installing the Ethernet Connection
The Aironet Wireless Ethernet Bridge supports three
connection types:
• 10Base2 (Thinnet)
• 10Base5 (Thicknet) AUI connector
• 10BaseT (Twisted Pair)
To Attach 10Base2 (Thinnet) Cabling:
1. Make sure the unit is powered off.
2. Attach the Thinnet cabling to each end of a BNC
T-connector, if applicable.
3. Attach the T-connector to the 10Base2 BNC. If the unit is at
the end of the Ethernet cable, a 50-Ohm terminator must be
installed on the open end of the T-connector.
NOTE: If you are installing a Token Ring Bridge,
proceed to page 2-6.
10Base2
10Base5
10BaseT
CAUTION: Removing a terminator to install extra cable, or
breaking an existing cable to install a T-connector, will
cause a disruption in Ethernet traffic. Consult with your LAN
administrator before you change any Ethernet cabling
connections.