User`s guide

Installation
2-2
2. Connect the lightning arrestor to one end of the low loss
antenna cable.
3. Connect the antenna to the other end of the low loss
antenna cable. Mount the Bridge antenna at an appro-
priate elevation to ensure maximum path clearance and
line of sight considerations.
NOTE: Do not over-tighten; finger tight is sufficient.
Position the antennas vertically for best omni-directional
signal reception.
NOTE: The lightning arrestor should be connected to the
antenna connector on the Wireless Bridge. The lightning
arrestor is added to provide surge protection to the Bridge
in the event of voltage surges as a result of a lightning
strike.
NOTE: Due to FCC and DOC Regulations, the antenna
connectors on the Aironet Bridge are of reverse polarity to
the standard TNC connectors.