User`s guide

Setting Ethernet Parameters

The Ethernet port has three parameters (Active, Size, and

Port) whose default settings are already correct for most

basic installations. You should probably need to make no

changes to any of the Ethernet parameters. Go on to the

"Disconnecting the Terminal" section. If you require

additional information refer to the

BR1000-E/BR2000-

E/BR2040-E Technical Reference Manual

Disconnecting the Terminal

With the initial configuration of the unit finished, you need to

end the terminal session and disconnect the terminal (or

PC) from the Bridge’s serial port.

1. Power-off the Bridge.

2. Remove the serial cable connector from the

Bridge’s EIA-232-E port.

3. Power-on the Bridge.