User`s guide

28
3. Decide what to do next:
•
If you want to assign a specific hexadecimal SID to
the Bridge, type the hexadecimal number (less than
ffffff) at the prompt and press Enter.
•
If you want to let the unit select a random SID, type "r"
at the prompt and press Enter.
The selected SID appears at on the Configuration
Radio Menu.
4. Examine the default bit rate and frequency on the Con-
figuration Radio Menu, and decide what to do next:
The bit rate and frequency must match that of other
nodes on the RF network. The default bit rate is the
highest available, and the default frequency is the center
frequency. You can accept these defaults or change
them as follows. Type
Bitrate and then type the
applicable bit rate from the choices shown. Type
Frequency and then type the applicable frequency from
the choices shown.
5. Type "2" to select "Bitrate" from the Configuration Radio
Menu.
The prompt: "Enter rate in kb/s, one of [354, 500, 1000,
2000]:" appears.
6. Type the appropriate bit rate from the list provided and
then press Enter.
The new bit rate appears on the menu.
7. Type "3" to select "Frequency" from the Configuration
Radio Menu.