User`s guide

Connecting the 10Base2 Cable

1. Make sure the Bridge is turned off.

2. Connect one end of the Ethernet cable to one end of a

BNC T-connector (if applicable).

3. Slide the T-connector onto the Bridge’s 10Base2 BNC

connector and turn it until it locks into place, as shown in

the following figure.

4. Decide what to do next:

•

If the Bridge is at the end of the Ethernet cable,

connect a 50-ohm terminator to the open end of the

T-connector (shown in the preceding figure).

•

If it is not at the end, connect another end of the

Ethernet cable to the other end of the T-connector on

the Bridge.

5. Go to the "Connecting the Power Pack" section.