User`s guide

18
Connecting the Console Port Cable
Connecting the Bridge’s console port to a terminal or to a
PC running a terminal emulation program lets you configure
the Bridge’s software.
1. With the Bridge powered off, connect the console port
cable to the EIA-232-E port as shown below.
2. Connect the other end of the cable to the serial port of a
terminal or a PC running a terminal emulation program.
Make sure the terminal or PC is powered off.
Connecting the Ethernet Cable
The Ethernet model of the Wireless Bridge supports
10Base2 (Thinnet), 10Base5 (Thicknet), and 10BaseT
(twisted pair) cabling. If your system uses:
•
10Base2 cabling, go to the next section, "Connecting the
10Base2 Cable."
•
10Base5 cabling, go to the "Connecting the 10Base5
Cable" section.
•
10BaseT cabling, go to the "Connecting the 10BaseT
(Twisted Pair) Cable" section.