User`s guide

Installing the Hardware

Use the following procedures to install the Wireless Bridge

hardware.

Connecting the Antenna

1. With the Bridge powered off, attach the antenna to the

antenna connector as shown below.

Connect the antenna until it is finger-tight. Do not over-

tighten.

2. After it is connected, position the antenna vertically to

achieve an omni-directional pattern.

Note: If you are using a remote antenna with your

Bridge, connect the coaxial cable to the Antenna

connector. Only use antennas and cables supplied by

Aironet.

Note: Because of changes in FCC and DOC regula-

tions, the antenna connector on the Bridge is the

reverse polarity of the standard TNC connector.