User`s guide

5 - 2 Aironet Wireless Client
Using the Configuration Menu
The Ethernet or Serial Port is configured using the Configuration Menu.
To access this menu, select Configuration from the Main Menu then
select Ethernet or Serial from the Configuration Menu.
Ethernet Configuration Menu
Activating/Disabling the Ethernet Port (Active)
The active option is used to enable or disable the Ethernet Port connec-
tion. The default setting for active is “On”. You would only use this
option if you wanted to temporarily stop traffic from the attached
Ethernet.
Setting the Maximum Ethernet Frame Size (Size)
The size option allows you to increase the maximum size of frames
transmitted to and from the Ethernet infrastructure. Do not set the maxi-
mum frame size greater than 1518 unless you are running proprietary
software that allows you to exceed this maximum. You may set the value
between 1518 to 4096.
NOTE: After the parameter is changed, the unit must be restarted either
by powering it “Off” and then “On”, or by using the “Diagnostics Restart”
command for the change to occur.
Configuration Ethernet Menu
Option Value Description
1 - Active [ on ] - Connection active
2 - Size [ 1518 ] - Maximum frame size
3 - Add - Add a client address
4 - Remove - Remove a client address
5 - Display - Display the client address
Enter an option number or name, Ò=Ó main menu, <ESC> previous menu
>_
UCE.BK Page 2 Wednesday, February 10, 1999 12:10 PM