User`s guide

Configuring the Radio Network 4 - 11
Viewing Errors (Errors)
The errors option is used to view the Radio Error statistics that may
have occurred during the link test. See Chapter 8 “Viewing Statistics”.
Setting the Automatic Link Test Mode (Autotest)
The autotest option is used to control the automatic running of a link
test whenever a repeater associates to its parent. The test will use the
currently configured test parameters which, by default, runs a test to the
parent node.
n Off: An automatic test is never run.
n Once: Only one test is run the first time the unit associates to a par-
ent after powering on.
n Always: The test is run each time the unit associates to a parent.
During an automatic link test the three indicators on the unit will turn
green in a cyclic pattern to indicate a test is in progress. At the end of
the test, the indicators will be set to a solid pattern for 4 seconds to indi-
cate the test results. The particular pattern that will be displayed
depends on the percentage of packets lost during the test as shown in
Table 4.1.
UCE.BK Page 11 Wednesday, February 10, 1999 12:10 PM