User`s guide

Installing the Aironet Wireless Client for Ethernet or Serial 1 - 5
2. Set the terminal to 9600 Baud, No-Parity, 8 data bits, 1 Stop bit, and
ANSI compatible.
NOTE: If you are using a Serial Client, proceed to “Attaching the AC/DC
Power Pack and Powering On”.
Installing the Ethernet Connection
1. Make sure the unit is disconnected from the power source.
2. Plug the RJ-45 connector into the 10BaseT port (Twisted Pair) as
shown in Figure 1.4.
3. Connect the other end of the Twisted Pair cabling to the LAN
connection (such as the crossover part of a hub for the Multi-Client
or wired LAN for the Universal Client).
Figure 1.4 - Ethernet Cabling Connection
POWER
10BaseT
CONSOLE/RS232
RESET
ANT
UCE.BK Page 5 Wednesday, February 10, 1999 12:10 PM