User`s guide

Installing the Aironet Wireless Client for Ethernet or Serial 1 - 3
Installation
This section describes the procedures for installing the Aironet Wireless
Client.
Installing the Antenna
The Aironet Wireless Client comes with a 2 dBi dipole antenna.
1. With the unit disconnected from the power source, attach the
antenna to the antenna connector. (Figure 1.2)
NOTE: Do not over-tighten; finger tight is sufficient. Position the antenna
vertically for best omni-directional signal reception.
NOTE: The rubber grommet exerts pressure on the antenna-threaded nut
to maintain antenna position.
Figure 1.2 - Attaching the Antenna
POWER
10BaseT
CONSOLE/RS232
RESET
ANT
ANT
Ethernet Wireless Client
POWER
CONSOLE/RS232
RESET
ANT
ANT
Serial Wireless Client
UCE.BK Page 3 Wednesday, February 10, 1999 12:10 PM