User`s guide

Performing Diagnostics 11 - 11

è To Upload Firmware using FTP:

1. Select the dest option and type the IP address of the remote PC, host

or Aironet Wireless Client you are sending to. Press ENTER.

2. Select the username option and type the username for the remote

PC, host, or Aironet Wireless Client you are sending to. Press

ENTER.

If uploading to another Aironet Wireless Client, the username

option must have a value even though the value is not used by the

remote Aironet Wireless Client.

3. Select the password option and type the access password for the

remote PC, host, or Console. Press ENTER.

4. Select the ﬁlename option type the name of the ﬁrmware ﬁle you are

sending to the PC, host, or Aironet Wireless Client (including drive

and directory). Press ENTER.

If uploading to another Aironet Wireless Client, the ﬁlename option

must have a value even though the value is not used by the remote

Aironet Wireless Client.

5. Select the put option. The unit will begin an FTP session to the

remote host PC or Aironet Wireless Client.

Uploading the Unit’s conﬁguration (Conﬁg)

You may use this option to save the conﬁguration on a remote host or PC

in a format suitable for later downloading using FTP or BOOTP.

You are ﬁrst prompted for the name of the ﬁle to be created on the

remote system. Once the ﬁlename is entered the transfer will begin.

UCE.BK Page 11 Wednesday, February 10, 1999 12:10 PM