User`s guide

10 - 4 Aironet Wireless Client

Unable to locate IP address “ip address”

The unit was trying to send a packet to an IP address without knowing

the hardware node ID. When this occurs, the unit will use the ARP pro-

tocol to try to determine the proper address. This log is produced if there

was no answer to the ARP request. Usually the unit is trying to ﬁnd the

destination for the SNMP traps.

Severe Error Logs

Ethernet cabling problem

If no trafﬁc has been sent or received on the Ethernet cable in the last

10 seconds, the unit will send a packet to itself to test the connection. If

the transmission succeeds, the timer is reset. If it fails, this log is pro-

duced and trafﬁc for the connection will be discarded until the test suc-

ceeds.

Conﬁguration is too large to save

The number of commands in the conﬁguration is too large for the avail-

able non-volatile memory. This may be caused by too many non-volatile

entries in the association table.

Could not program the ﬂash memory

An error occurred when trying to program a new version of the ﬁrmware

into ﬂash memory. The unit must be serviced.

Lost our association, max radio retries

The unit, conﬁgured as a repeater, lost communications with its parent

node after trying to send a packet the maximum number of times. The

unit will try to re-associate. The problem may be a parent Aironet Wire-

less Client failure. All local associations will be dropped.

UCE.BK Page 4 Wednesday, February 10, 1999 12:10 PM