User`s guide

Aironet Wireless Communications, Inc. 7-23 Confidential and Proprietary
Enable Command
The Enable command is used to start operation of the card after writing the configuration information.
Enable Command
Command (0x00) Param0 (0x02) Param1 (0x04) Param2 (0x06)
0x0001 0x0000 0x0000 0x0000 Basic Enable
This option enables both the
MAC and receive operations
0x0101 0x0000 0x0000 0x0000 Enable Only the MAC
Allows the PC4500/4800 to
associate to an AP, but no
received packets will be passed
to the host.
(Required for NDIS3 which
cannot install interrupt handler
until long after the card has been
configured and started.)
0x0201 0x0000 0x0000 0x0000 Enable Receive
Enable Responses = Success
Status (0x08) Resp0 (0x0A) Resp1 (0x0C) Resp2 (0x0E) Description
0x0001 0x0000 0x0000 0x0000 Successful Enable command
Enable Responses = Failure
Status (0x08) Resp0 (0x0A) Resp1 (0x0C) Resp2 (0x0E) Reason
Error Qualifier RID RID Offset
0x7F01 0x0002 0x0000 0x0000 Illegal format (Command)
0x7F01 0x0006 0x0000 0x0000 Is enabled already
0x7F01 0x0003 …. ….. Invalid RID as follows
0x7F01 0x0080 0xFF10 0x0002 Invalid Mode
0x7F01 0x0083 0xFF10 0x0004 Invalid Receive Mode
0x7F01 0x0084 0xFF10 0x000A Invalid Mac Address
0x7F01 0x0086 0xFF10 0x0022 Invalid Ordering Selection
0x7F01 0x0087 0xFF10 0x0030 Invalid ScanMode
0x7F01 0x0088 0xFF10 0x003E Invalid Authentication Type
0x7F01 0x0089 0xFF10 0x0050 Invalid Power Save Mode
0x7F01 0x0082 0xFF10 0x0060 Invalid Beacon Interval
0x7F01 0x0081 0xFF10 0x0064 Invalid Hop Interval
0x7F01 0x008A 0xFF10 0x0070 Invalid Radio Type
0x7F01 0x008B 0xFF10 0x0072 Invalid Diversity
0x7F01 0x008C 0xFF11 XXXX Invalid SSID list entry
0x7F01 0x008D 0xFF12 XXXX Invalid Specified AP entry