User`s guide

Installation
2-3
Installing the Ethernet Connection
The Aironet Access Point for Ethernet supports three
connection types:
• 10Base2 (Thinnet)
• 10Base5 (Thicknet) AUI connector
• 10BaseT (Twisted Pair)
To Attach 10Base2 (Thinnet) Cabling:
1. Make sure the unit is powered off.
2. Attach the Thinnet cabling to each end of a BNC
T-connector, if applicable.
3. Attach the T-connector to the 10Base2 BNC. If the unit
is at the end of the Ethernet cable, a 50-Ohm terminator
must be installed on the open end of the T-connector.
NOTE: If you are installing a Token Ring Access Point,
proceed to page 2-5.
10Base2
10Base5
10BaseT
CAUTION: Removing a terminator to install extra cable, or
breaking an existing cable to install a T-connector, will cause a
disruption in Ethernet traffic. Consult with your LAN adminis-
trator before you change any Ethernet cabling connections.