User`s guide

Installation

2-2

2. If you are using the Aironet Access Point with a remote

antenna, connect the coaxial cable to the antenna

connector. Only use antennas and cables supplied by

Aironet Wireless Communications.

Installing the Console Port Cable

1. Attach the Console Port cable to the Serial Port. Attach

the other cable end to the Serial Port on a terminal or a

PC running a terminal emulation program. Use a 9-pin

male to 9-pin female straight through cable.

2. Set the terminal to

9600

Baud,

-Parity,

data bits,

Stop bit, and ANSI compatible.

NOTE: Due to FCC and DOC Regulations, the antenna

connectors on the Aironet Access Point are of reverse

polarity to the standard TNC connectors.

NOTE: This connection is required for setting up initial

conﬁguration information. After conﬁguration is

completed, this cable may be removed until additional

conﬁguration is required via the Serial Port.