User`s guide

6 - 2 Ethernet or Token Ring Bridge
Using the Configuration Ident Menu
Network identifiers are entered using the Configuration Ident Menu
shown below. To access this menu, select Configuration from the Main
Menu then select Ident from the Configuration Menu.
Establishing a Node Name (Name)
The name option is used to establish a unique node name for the Ether-
net or Token Ring Bridge. The name is a text string of up to 20 charac-
ters that appears on all Console Port Menus. It is passed in association
messages to other nodes on the radio network. See Chapter 10 “Setting
Up the Association Table”.
Resetting the Default Network ID (NID)
The NID option displays the network ID of the Ethernet or Token Ring
Bridge. The default network ID, assigned at the time of manufacture, is
a global administered unique, 6-byte network address.
Typically, there is no need to use a value other than the default network
ID. However, if your LAN addresses are locally administered, you may
want to change the value of this parameter to match those used on your
LAN. No two units can be assigned the same address.
To set the value to the default programmed into the hardware, select
“default” when prompted.
Configuration Ident Menu
Option Value Description
1 - Name [ "BRE105E_22erba" ] - Node name
2 - Nid [ 00409622ef0a ] - Network address
3 - Inaddr [ 149.023.130.044 ] - Internet address
4 - Inmask [ 255.255.255.000 ] - Internet subnet mask
5 - Routing [ menu ] - IP routing table configuration
6 - Location [ "" ] - SNMP system location
7 - Contact [ "" ] - SNMP system contact name
Enter an option number or name, Ò=Ó main menu, <ESC> previous menu
>_