User`s guide

Configuring the Ethernet or Token Ring Port 5 - 7
Early Token Release (Earlyrls) Token Ring Only
This option only appears when used with a 16 Mb ring. Typically, a node
transmits a packet after receiving the token. It then retransmits the token
once it has seen the packet come back after traversing the ring. The
early release option allows the unit to transmit the token immediately
after transmitting a packet. This allows for more than one packet to be
traversing the ring at a time. The default value for 16 Mb ring is on. This
option should only change after consulting with your network adminis-
trator.
Control Frame Saps (Sap) Token Ring Only
This item is for internal use only.
Using the Token Ring Address Menu
When a radio client node is associated to a Token Ring Bridge and needs
to communicate with a Token Ring node, conversion of multicast
addresses may be necessary. The radio node reads as though it is
attached to an Ethernet port. The Token Ring nodes are only able to
receive a restricted form of multicast address.
Destination addresses, in the association table, are converted to the
Ethernet form on receipt from the Token Ring. The addresses are then
converted to the Token Ring form when transmitted to the Token Ring.
To add an entry, enter the Ethernet address and the equivalent Token
Ring address. To delete an address, specify all addresses or a specific
Ethernet address.
Configuration Token Ring Address Menu
Option Value Description
1 - Display - Display the conversion entries
2 - Add - Add a conversion entry
3 - Remove - Remove a conversion entry