User`s guide

Configuring the Radio Network 4 - 13
The Autotest procedure can be used to help determine the placement of
repeater units. For example, at each prospective location, an installer
could cycle the power on the unit and watch the indicator displays for
the results of the link test. As the test begins to fail, the installer could
determine the radio range to the infrastructure and adjust the location
accordingly.
Continuously Running a Link Test (Continuous)
The continuous option is used to continuously repeat the link tests. If
the value for the parameter is zero the tests are not repeated; otherwise,
the value determines the delay (in seconds) between tests.
Using the Configuration Radio Extended Menu
The extended radio parameters are not normally modified, but some may
have to be changed when certain situations arise.
The Menu will display different options, depending on whether your
unit is serving as an infrastructure or a repeater.
Configuration Radio Extended Menu
Option Value Description
1 - Time_retry [ 8 ] - Number of seconds to retry transmit
2 - Count_retry [ 0 ] - Maximum number transmit retries
3 - Balance [ off ] - Load balancing
4 - Diversity [ off ] - Enable the diversity antennas
5 - Power [ full ] - Transmit power level
6 - Fragment [ 2048 ] - Maximum fragment size
Enter an option number or name, Ò=Ó main menu, <ESC> previous menu
>_