User`s guide

Configuring the Radio Network 4 - 9
Running a Signal Strength Test (Strength)
The strength option sends a packet once per second to each node in the
association table. This packet is echoed back to the Ethernet or Token
Ring Bridge which records and displays the RF signal strength associ-
ated with that particular node.
It can be used to quickly check the link to each radio partner or could be
monitored while aligning directional antennas between two nodes. As
the antennas are moved, the signal strength could be monitored until the
maximum value is achieved.
SIGNAL LEVELS
BRxxxx 00409611d1e5 Strength In *******************************
Out **********************************
(^C to exit) |--------------------------------|
Configuration Radio Install Linktest Menu
Option Value Description
1 - Multicast - Run a multicast test
2 - Unicast - Run a unicast test
3 - Remote - Run a remote test
4 - Destination [ any ] - Target address
5 - Size [ 512 ] - Packet size
6 - Count [ 100 ] - Number of packets to send
7 - Errors - Radio error statistics
8 - Autotest [ once ] - Auto linktest mode
9 - Continuous [ 0 ] - Repeat test once started
Enter an option number or name, Ò=Ó main menu, <ESC> previous menu
>_