User`s guide

1 - 6 Ethernet or Token Ring Bridge
Installing the Ethernet Connection
NOTE: If you are installing a Token Ring Bridge, proceed to page 1-8.
The Ethernet Wireless Bridge supports three connection types:
n 10Base2 (Thinnet)
n 10Base5 (Thicknet) AUI connector
n 10BaseT (Twisted Pair)
è To Attach 10Base2 (Thinnet) Cabling:
1. Make sure the unit is powered off.
2. Attach the Thinnet cabling to each end of a BNC T-connector,
if applicable.
3. Attach the T-connector to the 10Base2 BNC (Figure 1.4). If the unit
is at the end of the Ethernet cable, a 50-Ohm terminator must be
installed on the open end of the T-connector.
CAUTION: Removing a terminator to install extra cable, or breaking an
existing cable to install a T-connector, will cause a disruption in Ethernet
traffic. Consult with your LAN administrator before you change any
Ethernet cabling connections.
Figure 1.4 - Attaching 10Base2 (Thinnet) Cabling
10Base2
10Base5
10BaseT