User`s guide

Installing the Bridge for Ethernet or Token Ring 1 - 3
Installation
This section describes the procedures for installing the Aironet Wireless
Bridge.
Installing the Antennas
Before installing your Bridge System, we recommend that you test the
Bridge using the 2.2 dBi dipole antenna included in your package. Once
testing is completed, install your Wireless Bridge for use with the
appropriate antenna for your application using the following the instruc-
tions.
1. With the unit powered off, attach the lightening arrestor to the
antenna connector.
NOTE: Do not over-tighten; finger tight is sufficient. Position the antenna
vertically for best omni-directional signal reception.
Figure 1.2 - Attaching the Antenna
STP
UTP
Token Ring
Ethernet
10Base2
10Base5
10BaseT