User`s guide

B-4 Ethernet or Token Ring Bridge
Maximum Maximum allow child nodes
Autoassoc Allow automatic table additions
Add Control node association
Remove Remove association control
Staletime Backbone LAN node stale out time
Niddisp Node Ids display mode
Filter Control packet filtering
Multicast Multicast address filtering
Default Default multicast action
Show Display the multicast filters
Add Add a multicast address filter
Remove Remove a multicast address filter
Radio_mcst Where to forward multicasts from radio
Node Node address filtering
Ethdst or Tkdst Destination address from Ethernet or Token Ring
Raddst Destination address from radio
Source Source addresses
Display Display the node address filters
Ipdisplay Display the IP address filters
Add Add a node address filter
Remove Remove a node address filter
Protocols Protocol filters
Default Default action
Display Display the protocol filters
Add Add a protocol filter
Remove Remove a protocol filter
Length Length of packet data to log
Monitor Protocol monitoring enabled
Show Show forwarded protocol list
Clear Clear forwarded protocol list
Direction Packet direction affected by filters
Logs Alarm and log control
History Log and alarm history
Clear Clear the history buffer
Printlevel Type of logs to print
Loglevel Type of logs to save
Ledlevel Type of logs to light status led
Statistics Set alarms on statistics
Bnodelog Log backbone node changes
Syslog Unix syslogd address
Lockled Enable LED status locking
Diagnostics Maintenance and testing commands
Network Network connection command
Connect Start telnet session
Escape Connection escape sequence
Find Flash LEDs to find unit
Ping Send an IP PING packet
Linktest Run a link test