User`s guide

B-3
Snmp Set snmp values
Enabled Enable the SNMP agent
Communities Set community properties
Display Display communities
Add Add a community
Remove Remove a community
Access Set community access mode
Ipadr Set allowed NMS IP addresses
Nid Set allowed NMS node ids
Remote Allow remote NMS to change community
Trapdest IP destination for SNMP traps
Trapcomm Community for SNMP traps
Loglevel Type of logs to cause a trap
Authtrap Enable authentication failure trap
STP Spanning Tree Protocol
Active Protocol enabled
Bridge Bridge parameters
Priority Bridge priority
Hello_time Hello message interval
Forward_delay Forwarding delay
Msg_age_timeout Receive hello message timeout
Port Port parameters
Port Protocol enabled for Ethernet or Token Ring port
Priority Local Ethernet or Token Ring port priority
Cost Local Ethernet or Token Ring port cost
Rport Protocol enabled for remote port
Rpriority Remote port priority
Rcost Remote port cost
Display Protocol status
State Local Ethernet or Token Ring port state
More More items
Dump Dump configuration to console
Statistics Display statistics
Throughput Throughput statistics
Radio Radio error statistics
Ethernet or Token Ring Ethernet or Token Ring error statistics
Status Display general status
Watch Record history of a statistic
History Display statistic history
Nodes Node statistics
ARP ARP tables
Display_time Time to re-display screens
Association Association table maintenance
Display Display the table
Summary Display the table summary
Monitor Monitor network associations
Map Show network map
Trace Trace network associations