User`s guide

Using Filters 11 - 15
Removing an Entry (Remove)
Use the remove option to remove a protocol filter entry. You may either
remove all filters by entering the keyword “all” or a single entry by
entering the number assigned to the filter and shown at the start of the
line in the filter display.
Length of Data Displayed in Log Action (Length)
Use the length option to display the contents of packets being forwarded
to the radio.
Use this option to setup the filter mask values to properly narrow down
which packets are filtered.
If you add a protocol filter whose action is “log,” each time the filter
matches, the contents of the data portion of the packet (after the MAC
header) will be displayed on the console (in hexadecimal) for a length in
bytes determined by the value of this option.
The contents of the data portion displayed in the information log will
consist of:
n “p”
n Id number of the filter shown on the Protocol Filters screen
n Bytes of the packet displayed in hexadecimal
More than one protocol at a time can be set with a filter action of “Log”.
The following is an example of a protocol filter log entry:
p2: 01 e0 ff ff 01 eo 00 04 00 00 01 65 ff ff ff ff ff ff 04
52 00 00