User`s guide

xii Ethernet or Token Ring Bridge
About the Technical Reference Manual
This manual covers the installation, configuration, control, and
maintenance of your Ethernet or Token Ring Bridge.
Please read
Chapter 1 – Installing the Ethernet or Token Ring Bridge
before attempting to install or use the hardware and software described
in this manual.
The technical reference manual is arranged as follows:
Chapter 1 – Installing the Ethernet or Token Ring Bridge – Describes
the physical installation of the Ethernet or Token Ring Bridge.
Chapter 2 – Accessing the Console Port – Introduces you to the Console
Port and shows you how to set up and configure the Console Port
parameters.
Chapter 3 – Before You Begin – Provides you with an overview of the
Configuration Menu and how to save and restore your configurations.
Chapter 4 – Configuring the Radio Network – Contains detailed
procedures for configuring your Radio Network.
Chapter 5 – Configuring the Ethernet or Token Ring – Contains detailed
procedures for configuring the Ethernet or Token Ring port.
Chapter 6 – Setting Network Identifiers – Outlines the procedures for
setting the Ethernet or Token Ring Bridge’s Network Identifiers.
Chapter 7 – Configuring SNMP – Describes how to configure the
Ethernet or Token Ring Bridge for use with the Simple Network
Management Protocol.
Chapter 8 – Using the Spanning Tree Protocol – Describes how to con-
figure the Ethernet or Token Ring Bridge for use with Spanning Tree
Protocol.
Chapter 9 – Viewing Statistics – Describes how to use the Statistics
Menu to monitor the performance of the Ethernet or Token Ring Bridge.