User`s guide

Configuring SNMP 7 - 7
Specifying Community Names for Trap Messages (Trapcomm)
Use the trapcomm option to specify the community name that will be
used in the trap message.
Specifying the Type of Log to Cause an SNMP Trap (Loglevel)
The Ethernet or Token Ring Bridge may be configured to generate an
enterprise specific trap whenever a log of a given severity or higher is
produced. The trapdest parameter must be “On”.
The generated trap will contain the text of the log message along with
the severity of the log. See the MIB definition files for the exact layout
of the trap. The different severities are:
n Error/Severe: Displays all Error and Severe Logs
n Severe: Displays Severe Error Logs only
n All: Displays all Error, Severe, and Information Logs
n Off: No Event Logs will be displayed
See Chapter 12 “Setting Up Event Logs”.
Enabling Authentication Failure Trap (Authtrap)
Use the authtrap option to control the generation of SNMP authentica-
tion failure traps.
The failure traps may be sent if an NMS sends a request with an
unknown community name or a community name that it is not allowed
for use. You can enable or disable this option. The default setting is
“Off”.