User`s guide

Utilities

4-8

Loading Firmware for Windows 3.11

and DOS

The FLSH3545.COM program is used to load new ﬁrmware

to systems operating under DOS and Windows 3.11.

To load new ﬁrmware:

1. Before upgrading the ﬁrmware, uninstall the driver or

reboot the computer and do not load the driver during

the boot process.

2. Type FLSH3545 at the DOS prompt.

3. Enter the option (see Table below).

4. Type the ﬁlename of the new ﬁrmware.

5. Press Enter.

Utility Description

-p Speciﬁes the starting address for a block of 64 con-

secutive 16-bit I/O ports. Make sure the block of I/O

addresses does not overlap the address of another

device in the machine. This can be used to override

a card service assignment. If card services are not

used, this will default to 0x140.

-s Optional – If card services are used, this parameter

is ignored. If card services are not used, this is the

PC Card socket the PC Card is inserted into

(default is 0).

-m If card services are used, this parameter is ignored.

If card services are not used, this is a block of mem-

ory the driver will use to view the PC Card CIS

(default is 0xD000).

-q Quiet Mode, no messages will appear while ﬂash

upgrade is in progress.