User`s guide

Installing the Software

3-4

Windows 95 or Windows 98 NDIS3

Installation

To complete the installation of the Wireless LAN Adapter

using Windows 95 or Windows 98:

NOTE: Expansion cards cannot share the same Base

Address or IRQ. Check the switch settings on the

ISA4500 or ISA4800 to ensure they do not conﬂict with

other expansion cards in the computer.

NOTE: PnP must be enabled. See “Conﬁguring the DIP

Switches (ISA Only)” in Section 2.

1. Power on your computer and boot Windows.

2. Windows will display the New Hardware Found

dialog box.

3. When prompted for the manufacturer’s disk, insert

the disk provided with the adapter into the appropri-

ate drive.

4. Type A:\NDIS3 at the prompt and press Enter.

5. Select the appropriate Infrastructure Mode and enter

the SSID of the wireless network.

6. Select the Bitrate parameters.

7. Press Enter.

8. Windows will prompt for the system disks. Enter the

correct network path.

9. Restart Windows after the ﬁles are copied. The

system will reboot and the installation will be

complete.

Choosing the adapter from the Network Icon and selecting

Properties will allow the setting of additional parameters.

See

Driver Keywords and Settings

for information.