User`s guide

Installation
2- 3
Installing the Ethernet Connection
The Aironet Access Point supports three connection types:
•
10Base2 (Thinnet)
•
10Base5 (Thicknet) AUI connector
•
10BaseT (Twisted Pair)
To Attach 10Base2 (Thinnet) Cabling:
1. Make sure the unit is powered off.
2. Attach the Thinnet cabling to each end of a BNC
T-connector, if applicable.
3. Attach the T-connector to the 10Base2 BNC. If the
AP3500-E is at the end of the Ethernet cable, a
50-Ohm terminator must be installed on the open end of
the T-connector.
CAUTION: Removing a terminator to install extra cable, or
breaking an existing cable to install a T-connector, will
cause a disruption in Ethernet traffic. Consult with your LAN
administrator before you change any Ethernet cabling
connections.
10Base2
10Base5
10BaseT