User`s guide

Installation
2- 1
Installation
This section describes the procedures for installing the
Aironet Access Point.
Installing the Antennas
The AP3500-E comes with two antennas.
1. With the unit powered off, attach both antennas to the
antenna connectors.
NOTE: Do not over-tighten; finger tight is sufficient. Position
the antennas vertically for best omni-directional signal
reception.
2. If you are using the Aironet Access Point with a remote
antenna, connect the coaxial cable to the antenna
connector. Only use antennas and cables supplied by
Aironet Wireless Communications.
NOTE: Due to FCC and DOC Regulations, the antenna
connectors on the Aironet Access Point are of reverse
polarity to the standard TNC connectors.
10Base2
10Base5
10BaseT