User`s guide

Utilities 3 - 11
Steps for Diagnostic Testing
The procedures for completing the Aironet PCMCIA diagnostic testing
are described in detail throughout the chapter. In general, the basic steps
are as follows:
1. Run ARLANDGS.EXE.
2. Select the found Client Card and view the current system configura-
tion parameters.
3. Perform Quick Setup (if new to Aironet products).
4. Save the configuration.
5. Configure the Aironet Client Card with the new parameters (tests
hardware).
6. Run a Linktest to test the link quality.
Navigating ARLANDGS Menus
ARLANDGS uses a DOS-based Graphical User Interface (GUI) consist-
ing primarily of menus. You can navigate through the menus using the
keyboard or the mouse (assuming a mouse driver has been installed).