User`s guide

Client Card Driver Installation 2 - 7
ODI Driver Installation
You can install the Aironet Client Card in an ODI-compliant DOS envi-
ronment such as Novell Netware.
This installation procedure requires the following software.
DOS 2.0 or higher
Aironet Configuration diskette
Refer to the applicable LAN operating system documentation for
instructions on installing third-party drivers and use the following pro-
cedures as guidelines.
Installation Guidelines
1. Copy the A:\ODI\DOS\1200-2200\AWCO1200-2200.COM driver
from the Aironet Configuration diskette to the network directory on
the boot disk.
2. Copy the A:\ODI\DOS\1200-2200\NET.CFG file from the Aironet
Configuration diskette to the network directory on the boot disk (do
not copy over the existing NET.CFG file), or edit your current
NET.CFG file to include the following lines:
If you are using an Aironet1200:
Link Driver AWCO1200
SystemId 000002 ;Even Number 6-hex digit system id
Channel 11 ;Defines which radio to use
(See
Appendix B - International Channel Sets
for a list of the available channels and
Chap-
ter 3 - Utilities
for a description of how to
select a channel.)
TMA ON ;Defines if ARLAN Mode is used
; OFF - Peer-to-Peer Mode
; ON - Normal ARLAN Mode
; PSP - Power Saving ARLAN Mode
Mem #1 D0000 ;PCMCIA Shared RAM address
;0xC000-0xDE00 valid
Int #1 5 ;PCMCIA IRQ 2-15 valid