User`s guide

Client Card Driver Installation 2 - 3
Installation Guidelines
1. Copy the A:\NDIS\DOS\1200-2200\AWCN1200-2200.DOS driver
file from the Aironet Configuration diskette to the network directory
on the boot disk.
2. Modify the CONFIG.SYS file by adding the following after the line
containing, Device=PROTMAN.DOS.
Device=[drive:][path]AWCN1200-2200.DOS
3. Edit your current PROTOCOL.INI file to include the following
lines. These lines are in the sample file
A:\NDIS\DOS\1200-2200\PROTOCOL.INI.
If you are using an Aironet 1200:
[AIRONET]
Driver Name=ARLAN$
SystemId=0x000002 ;Even Number 6-hex digit system id
Channel=11 ;Defines which radio channel to
;use
(See
Appendix B - International Channel Sets
for a list of the available channels and
Chap-
ter 3 - Utilities
for a description of how to
select a channel.)
TMA=ON ;Defines if ARLAN Mode is used
; OFF - Peer-to-Peer Mode
; ON - Normal ARLAN Mode
; PSP - Power Saving ARLAN Mode
Mem=0xD000 ;PCMCIA Shared RAM address
;0xC000-0xDE00 valid
Int=5 ;PCMCIA IRQ 2-15 valid
Socket=1 ;PCMCIA Socket, 1 or 2 valid
If you are using an Aironet 2200:
[AIRONET]
Driver Name=ARLAN$
SystemId=0x000002 ;Even Number 6-hex digit system id
DataRate=4 ;Defines which data rate to use
Channel=3 ;Defines which frequency to use