User`s guide
Client Card Installation 1 - 3
Installing the Radio Module and Client Card
NOTE: Before mounting the Radio Module, install the Client Card and ver-
ify that it is working properly with your computer. This step will also pro-
vide you with a better idea of where to mount the Radio Module so that
the tether cable is never strained.
To Mount the Radio Module:
1. Slide the mounting plate off of the bracket on the back of the Radio
Module.
2. Peel the plastic from the back of the mounting plate to expose the
glued surface.
3. Position the mounting plate on the computer so that when the Radio
Module is attached, the antenna will point in an upward direction,
and where possible, above the top edge of the computer. This
ensures the best radio range during normal operations.
4. Slide the back of the Radio Module onto the mounting plate until the
Radio Module is positioned firmly in place. See
Figure 1.2
.
Figure 1.2 - Mounting the Radio Module
i