User's Manual

M.AO00059-Rev.04
Installation Manual
Warning: This device must be professionally installed by Airobotics certified technician
Needed materials:
• AO00059 LoRa transmitter module
• Antenna (FW.95.B.SMA.M/ S463AM-915)
• Remote control – Futaba T14SG for example
• 3S LiPo battery with XT60 connector
• Trainer port to LoRa cable
• Thread-lock - Loctite 243(Airobotics P/N: 001339)
Connection instructions:
1. Connect the specified antenna to the AO00059 LoRa module
Antenna installation notes:
• Use thread-lock to permanent secure the SMA antenna connection.
• Take extra care when attaching the Antenna SMA connector, Finger tight with approximately
torque of 0.6-0.8Nm is sufficient.
Warning: It is absolutely forbidden for any operator to modify or change the device antenna. In the event the need
arises to replace the antenna, replacement of the antenna shall only be performed by a professional installer.