Assembly Instructions

OPT1-M-104 Rev.01 Optimus-1 EX - FTS Mast Assembly Procedure
Page 14 of 33
To mount the FTS Mast Unit Box on the mast, do the following:
1. Attach the FTS cabinet to the mast with hold hanging (metal pole clamp) brackets, using
the screws that were prepared in advance (see Table 1 and Figure 6).
2. Attach the Plate Holders to the cabinet walls and to the clamps using the screws,
washers and Nylock nuts that were prepared in advance (see Table 1 and Figure 7).
Figure 6 Attach the hold hanging (metal pole clamp) brackets to the mast
Figure 7 Attach the plate holders to the brackets and cabinet back