Specifications

Installation and Operation Manual Chapter 4 Configuration
Airmux-200 Ver. 1.750 Setting the Maximum Information Rate 4-21
 To configure the Ethernet Mode:
1. From the Configuration menu, select the site to reconfigure.
The Site Configuration dialog box opens.
2. Click Advanced > Ethernet.
3. In the Ethernet Ports Configuration pane, use the drop-down menu to select
the LAN configuration.
4. Click Apply to save the changes.
It is possible to close the Ethernet service by disconnecting the Ethernet port.
The user should be aware that it is possible to close the port and not have any
access to the device. If this should occur the workaround is as follows:
• Connect the system from the remote site
• Connect via other Ethernet port (IDU-E)
• Power down the equipment and connect immediately after the power up (the
fastest way is to enter install mode).
4.12 Setting the Maximum Information Rate
The maximum Ethernet throughput of the link can be limited. The default setting
is Best Effort, where the highest information rate available for the link conditions
and settings is used. (See
Figure 4-16 )
 To set the Ethernet information rate:
1. From the Configuration menu, select the site to reconfigure.
The Configuration dialog box opens.
2. Click Advanced > Ethernet
3. In the Information Rate pane, use the drop-down menu to select the
maximum Information Rate.
 Select Other to define the throughput with 8 Kbps resolution
 Select Best Effort for the highest information rate possible for the link
conditions and settings.
4. Click Apply to save the changes.
Airmux-200-L systems have a maximum rate of 2048 kbps.
Note
Note