Specifications

Airmux-200 Ver. 1.750 Configuring the System Parameters 4-1

Chapter 4

Configuration

This chapter describes configuration procedures, which are performed after the

physical installation of the local and remote Airmux-200 units and the Installation

Link wizard has been performed. A second wizard is used to redefine the

configuration parameters if necessary. Both sites in the link are defined

simultaneously.

The following parameters are configured via the Configuration Wizard:

• System parameters

• Frequency channel

• Air interface rate

• Service parameters

• TDM

• Hub Site Synchronization Settings.

The following parameters are configured via the Configuration dialog box.

• Transmit power

• Management and trap addresses

• Bridge mode

• Ethernet mode

• VLAN management

• Community values.

For HSS screens see

Appendix F

4.1 Configuring the System Parameters

After installing the link, the system configuration can be modified.

All parameter changes are automatically applied to both sides of the link.

 To change general parameters:

1. In the Main menu, click the Link Configuration button.

2. The Configuration wizard opens (

Figure 4-1

Note