Specifications

Installation and Operation Manual Chapter 2 Installation and Setup
Airmux-200 Ver. 1.750 Connecting the User Equipment 2-25
Figure 2-20. Installation Wizard, Finish Screen
4. Click Finish to complete the installation wizard.
When the wireless link is established between the site A and site B units, the
Quality bar is within the yellow area for Ethernet only links, or within the
green area for Ethernet plus TDM links.
5. Verify that the Radio Signal Strength (RSS) is according to expected results as
determined by the Link Budget Calculator.
2.14 Connecting the User Equipment
The IDU is a standalone desktop, wall-mounted or rack-installed unit. Figure 2-2
illustrates a typical rear panel of the IDU.
 To connect user equipment to the IDU:
1. Connect user E1/T1 traffic to the IDU panel RJ-45 port designated TRUNK.
There may be multiple trunk ports available depending on unit ordered.
Refer to
Appendix A for the connector pinout.
2. Connect user hub/router or any other compatible device to the IDU panel
RJ-45 port designated LAN. There may be multiple LAN ports available for