Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-20 Installing the Link Airmux-200 Ver. 1.750
Selecting the Service Parameters
The user defines the type of service required, Ethernet Only or Ethernet with
TDM. The bandwidth remaining available for Ethernet if TDM services are required
is shown in the dialog box.
Airmux-200-L versions are Ethernet Only.
Figure 2-17. Installation Wizard, Services Dialog Box
 To select the services:
1. In the Service dialog box, select one of the following:
 E1/T1 – E1/T1 data and Ethernet data.
The Ethernet BW field shows the remaining bandwidth in Mbps available
for Ethernet. The available bandwidth depends on the number of E1/T1
ports selected.
 Ethernet Only
2. Select the required transmission rate.
If Adaptive is selected Airmux-200 constantly monitors and adjusts the
transmission rate to ensure maximum throughput for the link at the highest
quality. Airmux-200-L versions are preset to adaptive and the rate selection is
disabled.
Note