Specifications

Chapter 2 Installation and Setup Installation and Operation Manual

2-18 Installing the Link Airmux-200 Ver. 1.750

When changing the channel bandwidth Airmux-200 repeats evaluation of

the link.

ACS is disabled if 5 or 10 MHz channel bandwidth are selected.

F2.x GHz versions with TDM services operate at 10 or 20 MHz steps only.

Ethernet Only also supports 5 MHz bandwidth.

3. Click the check box if Automatic Channel Selection is required.

4. Click the check boxes in the Available Channels List of all the allowable

channels that can be automatically selected.

Selecting a new channel causes the system quality to change. The quality bar

shows the adjustment until the system finds the best quality link.

5. If you are not satisfied with the channel that is selected automatically, click

Reselect Channel.

A new channel is selected from one of the Available Channels that has

been defined.

6. Click Next.

The Evaluating Rate box appears. When the optimum rate for the link is

selected the Service Parameters dialog box opens.

Airmux-200 5.4 GHz ETSI Version

In accordance with ETSI, if Airmux-200 detects Radar interference it changes the

frequency channel automatically. This feature is termed Dynamic Frequency

Selection (DFS). In this version, the Automatic Channel Selection is selected by

default and a minimum of two channels must be defined as available.

1. Select the main frequency from the Operating Channel menu.

2. Select the Bandwidth required.

Automatic Channel Selection is selected by default.

3. Click at least two check boxes in the Available Channels List of all the

allowable channels that can be automatically selected.

Installation will not continue until at least two channels are defined.

Selecting a new channel causes the system quality to change. The quality bar

shows the adjustment until the system finds the best quality link.

Any channel selected is evaluated for 60 seconds; therefore this selection

process may take a few minutes.

4. If you are not satisfied with the channel that is selected automatically, click

Reselect Channel.

A new channel will be selected from one of the Available Channels that

has been defined.

5. Click Next.

Not

Note