Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-10 Starting the Airmux-200 Manager Software Airmux-200 Ver. 1.750
4. Coarsely align the site B ODU in the direction of the site A ODU.
5. Make an azimuth sweep of 180 degrees with the site A ODU. So that the
strongest signal from site B can be detected.
6. Slowly turning the site A ODU back towards the position of site B, listen to
the beeps until the best signal is reached.
Figure 2-7 indicates the beeper
signals with the black representing the beeps.
Figure 2-7. Beeper Sequence for ODU Alignment
Three beeps and a pause indicates the best signal.
Two beeps and a pause, indicates signal quality has increased.
One beep and pause indicates no signal change.
Any other sequence detects no signal between the ODUs.
7. Secure the site A ODU to the mast or wall.
8. At site B, adjust the ODU slowly while listening to the beeper sequence until
the best signal is attained.
9. Secure the site B ODU to the mast or wall.
10. Monitor the link quality for about 15 minutes to verify stability.
2.11 Starting the Airmux-200 Manager Software
 To start the Airmux-200 Manager:
1. Connect the management station to the LAN.
2. Double-click the Airmux-200 Manager icon on the desktop, or click Start >
Programs > Airmux-200 Manager.
The login dialog box appears:
Note