Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-6 Connecting the ODU or O-PoE to the IDU Airmux-200 Ver. 1.750
 To connect the ODU or O-PoE to the IDU
1. ODU: Route the cable from the ODU to the IDU.
O-PoE: Route the cable from ODU to O-PoE along the mast or wall.
2. Secure the cable along its path.
3. ODU: Connect the ODU-IDU cable to the RJ-45 connector on the IDU
designated ODU or WAN.
O-PoE: Connect the ODU-IDU cable to the RJ-45 connector on the O-PoE
designated PoE.
The figures below illustrate typical IDU panels. There may be differences in panels
depending on the hardware ordered.
TRUNK 1
LANODU
DC IN
48-60V --- 1A
+
-
TRUNK 2
Figure 2-2. Typical IDU Rear Panel
Figure 2-3. Typical IDU-E Front Panels
Figure 2-4. Airmux-200-AIND All Indoor Radio Unit
Figure 2-5. Airmux-200 PoE-8