Specifications

Installation and Operation Manual Appendix G BRS Installation Procedure
Airmux-200 Ver. 1.750 BRS Link Configuration G-3
Figure G-3. BRS Channel Settings Pre-Transition
8. Perform the remainder of the Installation procedure as defined in the
Installation section.
G.2 BRS Link Configuration
The BRS link is reconfigured during the Link Installation or the Link Configuration
wizards, or from the Air Interface screen.
Both sites in a BRS Link must be configured identically.
Any changes to the frequency settings cause the link to re-synchronize. A short
loss of service will occur during re-synchronization.
 To Configure BRS Channel Settings:
1. Set the Band Plan.
2. Select the Bandwidth required: Single Band or Double Band.
3. Select the Frequency from the pull-down menu.
4. Click Next. The system is re-synchronized to the changes.
Note