Specifications

Airmux-200 Ver. 1.750 Before the Installation 1
Quick Start Guide
Installation of Airmux-200 should be carried out only by a qualified technician. If
you are familiar with Airmux-200, use this guide to prepare the units for
operation. If you are not familiar with Airmux-200, please read the Installation
and operation Manual carefully.
1. Equipment Required
The following is a list of equipment required for installing an Airmux-200 link:
• RJ-45 crimp tool (if pre-assembled cable is not used)
• Drill (for wall mounting only)
• IDU and ODU grounding cables
• O-PoE 10AWG grounding cable
• 13 mm (½″) spanner/wrench
• ODU to IDU cable if not ordered (outdoor class, CAT-5e, 4 twisted pairs)
• ODU to O-PoE both cables (ETH and PoE) if not ordered (outdoor class,
CAT-5e, 4 twisted pairs)
• Cable ties
• Laptop running Windows 2000 or Windows XP.
2. Before the Installation
1. Verify that all equipment and tools are available.
2. Install the Airmux-200 software on the laptop; the installation takes several
minutes.
The software installation leaves the Airmux-200 Manager icon on the
desktop.
3. BRS systems only - Activate the link.