Specifications

www.airmar-emea.com
Parts & Accessories
Hull Inserts
86
Hull Inserts—Parts and Accessories
Bolt Pack for INS-BLANK:
33-443-01 ........€ CALL
The molded pocket system was developed to allow boat builders a way to provide factory transducer provisions into
their hulls. The molded pocket system forms a common transducer recess into the same location on each vessel
produced. The pocket is sized to accept the popular B260, SS260 and SS270W transducers with inexpensive inserts
available to allow installation of many other popular models.
A blank insert is also available for delivery of the vessel when no transducer has been installed.
The result is a “factory approved” ush transducer installation on every hull, providing predictable performance for the
electronics as well as the vessel, while still leaving the customer with choices in their transducer selection.
The pocket is sized for
an Airmar
®
B260 High-Performance
Transducer
...and adapters can be inserted
to allow ush installation of
other common models.
Blank
INS-BLANK
Net: € CALL
Blank hull insert ts into molded pocket and
is used when a transducer is not installed
at the factory.
B45
INS-B45
Net: € CALL
B45 hull insert ts into molded hull pocket
and allows ush mounting of a B45
transducer.
B744V, B744VL
INS-B744V
Net: € CALL
B744V hull insert ts into molded hull
pocket and allows ush mounting of a
B744V transducer.
B258
INS-B258
Net: € CALL
B258 hull insert ts into molded hull pocket
and allows ush mounting of a B258
transducer.
Mold Plug
INS-MOLDPLUG
Net: € CALL
A mold plug is available for forming a
transducer pocket into the hull during lay-
up. Electronic drawings are also available
that allow the pocket dimensions to be
imported into most popular CAD programs.