User`s manual

- 15 -
Press 0 and Enter (0 sets the networking settings to Static IP).
Press Enter again→ enter the IP address [IP] →
Press SPD/Hold→ a blinking cursor appears
Enter the IP address (XXX*XXX*XXX*XXX) and press Enter.
Press Enter again → the Subnet Mask parameter appears
Press SPD/Hold→ when the blinking cursor appears→
Enter the Subnet Mask information (XXX*XXX*XXX*XXX) and then press Enter.
Press Enter again→ the Router option appears
Press SPD/Hold→the blinking cursor appears,
Enter the Input Default Gateway Information (XXX*XXX*XXX*XXX) and the press
Enter.
Configuring for PPPoE
Connect the power adaptor to the AirLive ePhone-1000.
Connect the PPPoE network to the AirLive ePhone-1000 to its RJ-45 port.
Press1, 2, 3, 4, # (Hold the “#” key) enter a [Password]
Press 1, 2, 3, 4 and Enter→ the Network Settings option appears.
Press Enter→ enter the [iptype]
Press SPD/Hold→ When the blinking cursor appears Press 1 and then press Enter(1
sets the networking settings PPPoE).
Press Enter again→Enter the [pppid]
Press SPD/Hold→ Enter the PPPoE Account Number and press Enter.
Press Enter→ Enter the [pppin]
Press SPD/Hold
Enter the PPPoE password and press Enter→
Press Enter again to complete the configuration
Refer to the appendix when entering special Symbols such as @, A, a, B, b, C